Bridge Board
The Bridge Board acts as a bridge between a JeeNode (also USB or SMD variants) and a breadboard. All the I/O and power pins in one row, labeled for easy reference (including Arduino pin numbers), with two pins sticking into the power rail for ground and +3.3V. The JeeNode goes underneath, component-side up, with the radio on the right-hand side.
Two LEDs and a push button are also brought out, available for general-purpose use.
In the most basic form, the Bridge Board has just 4 6-pin male haders to push into the JeeNode ports, and 29 (+ 2 power-rail) pins to push into a medium or large size breadboard.
The generality of this setup increases if you hook up more headers between the JeeNode and the Bridge Board. With the SPI/ISP connector included, you get the ability to hook it up to an Ether Card, for example.
Configuration
There is nothing to configure.
Header Pinouts
Design Info
Dimensions: 36.3 x 76.9 mm
CadSoft EAGLE design files: see below.
How to Get It
http://shop.jeelabs.com/products/bridge-board
Related Weblog Posts
- 2010-10-28 - Meet the Bridge Board
- 2010-12-01 - Assembling the Bridge Board
- 2010-12-02 - Bridge Board - caveats
