Project

General

Profile

Carrier Card

The Carrier Card is a prototype board for use with the Carrier Board:

This Carrier Card can be separated into two parts. Both parts have a series of +3V pins along their left edge and a series of GND pins along their right edge.

All the header pins on the top row are labeled and connected to a free hole below. There’s a mounting hole to fasten the right side to the center of the bottom ABS shell.

Configuration

There is nothing to configure.

Header Pinouts

Design Info

Dimensions: 33 x 118 mm
CadSoft EAGLE design files: see below.

How to Get It

http://jeelabs.com/products/carrier-card

Related Weblog Posts