JeeNode Block (jb1)

The JeeNode Block was a one-time only design. It was given away as freebie on Jan 1st, 2012 - as described on this weblog post:

The main difference is that the RFM12B's interrupt line was reassigned from PD2 to PB1 to free the entire set of digital pins 0..7, i.e. PD0..PD7. This requires a modification to the RF12 driver.

There is a reset button, as well as an LED tied to PB0 (Arduino digital 8) via an extra resistor, which needs to be placed upright on the board because there is little space.

Mr. Murphy would like to point out that a mistake was made when assigning PB0 and PB1: the intention was to assign them the other way around.

Apart from the form factor and the above differences, the JeeNode Block is identical to a JeeNode.

Related Weblog Posts

DSC_2829.jpg (308 KB) jcw, 2012-01-03 15:14