Project

General

Profile

Proto Board

The Proto Board is a small add-on board which fits over all the connectors of a JeeNode or JeeNode USB (except the serial FTDI and USB connector, respectively).

The two “ends” of the board are slightly different to help identify the proper orientation of the board when placing it on a JeeNode.

All the pads on the board are unconnected and all the holes are plated-through so they can be used from either side of the board.

The pins of all the port headers are labeled on both sides of the board. The SPI/ISP and PWR/SER/I2C connectors can be tied to the JeeNode if needed, via their own headers at both ends of the board.

Configuration

There is nothing to configure. This board does not have any components or connections.

Header Pinouts

Design Info

Dimensions: 21.1 x 52.1 mm
CadSoft EAGLE design files: see below.

This board uses the conventions of a JeePlug and can be used with the ports on a JeeNode. It can also be used with other boards and MCU’s, if you hook it up properly and adapt the interface code for it.

How to Get It

http://jeelabs.com/products/proto-board


pb1.DSC_0643.jpg (18.4 KB) myra, 2012-07-17 15:34

pb1.DSC_0584.jpg (11.8 KB) myra, 2012-07-17 15:34

pb1.DSC_0591.jpg (11.7 KB) myra, 2012-07-17 15:34

pb1._00000235.png (67.6 KB) myra, 2012-07-17 15:34

jlpcb-037.brd (15.8 KB) myra, 2012-07-17 16:41

jlpcb-037.pdf (8.6 KB) myra, 2012-07-17 16:41

jlpcb-037.sch (25.5 KB) myra, 2012-07-17 16:41

jlpcb-037.png (61.9 KB) myra, 2012-07-17 16:41