RF12 Directory Reference

All example sketches related to the RF12.h wireless driver.

More...

Directories
directory	announcer
	Test sketch to send out "announcer" type management packets.
directory	crypRecv
	Test encrypted communication, receiver side.
directory	crypSend
	Test encrypted communication, sender side.
directory	fs20demo
	This example sends commands to the Conrad/ELV 868 MHz FS20 units via OOK.
directory	groupRelay
	Relay packets from one net group to another to extend the range.
directory	homePower
	Send incoming home power measurements as wireless packets.
directory	jouleTest
	Send out a radio packet every minute, consuming as little power as possible.
directory	kaku_demo
	This example sends commands to the KlikAanKlikUit units via OOK at 433 Mhz.
directory	ledNode
	Programmable color ramps for the LED drivers on the LED Node.
directory	ookRelay2
	Generalized decoder and relay for 868 MHz and 433 MHz OOK signals.
directory	ookScope2
	Examine the pulse patterns coming from an OOK receiver (see also peekrf).
directory	otRelay
	Read out the OpenTherm gateway and relay readings using RFM12B.
directory	p1scanner
	Parse P1 data from smart meter and send as compressed packet over RF12.
directory	packetBuf
	This example shows how to fill a packet buffer with strings and send them.
directory	pingPong
	Demo of a sketch which sends and receives packets.
directory	pollee
	This can run on several nodes, and get data to the central "poller" node.
directory	poller
	Polls a number of "pollee" nodes as fast as possible to get data from them.
directory	powerACS
	Measure power from an ACS714.
directory	radioBlip
	Send out a radio packet every minute, consuming as little power as possible.
directory	radioBlip2
	Send out a radio packet every minute, consuming as little power as possible.
directory	RF12_1byte
	Configure some values in EEPROM for easy config of the RF12 later on.
directory	rf12cmd
	Command-based central node for RF12 packets.
directory	RF12demo
	Configure some values in EEPROM for easy config of the RF12 later on.
directory	rf12serial
	Serial data over RF12 demo, works in both directions.
directory	rf12stream
	Streaming layer demo, transfers different types of data in both directions.
directory	RFM12B_OOK
	Receive / decode OOK signals using a RFM12B as 868 MHz OOK receiver.
directory	rfRangeRX
	Receive sketch used to report quality of reception.
directory	rfRangeTX
	Transmit sketch used to report quality of reception.
directory	rgbRemote
	Control some LED strips, using settings received by wireless.
directory	roomNode
	New version of the Room Node (derived from rooms.pde).
directory	slowLogger
	Report 4 analog inputs once every minute over wireless.
directory	smaRelay
	Read out SMA solar inverter via Bluetooth and relay readings using RFM12B.
directory	syncRecv
	Try to receive periodic transmissions with minimal power consumption.
directory	tickerLed
	Driver for the Conrad "lichtkrant" unit, i.e.
directory	timedRecv
	Experiment with time-controlled periodic reception.
directory	timedSend
	Experiment with time-controlled periodic transmission.
directory	tinyTest
	New version of the Room Node for the ATtiny85 (derived from rooms.pde).

Detailed Description

All example sketches related to the RF12.h wireless driver.