General

Profile

certeza

  • Email: info@certeza.nl
  • Registered on: 2014-11-01
  • Last connection: 2014-11-21

Issues

Projects

Activity

2014-11-06

22:28 JeeLabs Café Support: RE: RFM69CW board: who has it working?
I will keep in touch.
It use a raspberry pi as hub and several sensors and actuators based on arduino pro minis.
soft...
22:18 JeeLabs Café Support: RE: RFM69CW board: who has it working?
JohnO, you are my hero.
I would never have figured this out myself.
thnx a million!
now I can continue my work on my...
22:07 JeeLabs Café Support: RE: RFM69CW board: who has it working?
\> 1595o
A i1 g212 @ 868 MHz o1595
867.9750 MHz
Then ‘t’ gives:
test 0 -\> 66 b
OK 193 afc=0 fei=0 lna=6 temp=10 (...
21:57 JeeLabs Café Support: RE: RFM69CW board: who has it working?
I am only using 2 nodes, but I changed the id when I reinstalled.
21:54 JeeLabs Café Support: RE: RFM69CW board: who has it working?
Sender:
[RF12demo.13]D7
Config eeProm:
81D4010040060000000000000000CF22 GOOD CRC 0
Available comma...
21:46 JeeLabs Café Support: RE: RFM69CW board: who has it working?
I installed it again.
‘v’ gives:
[RF12demo.13] H i8 g212 @ 868 MHz
receiving node gives:
OK 33 28 29 30 31 32 33 34...
21:25 JeeLabs Café Support: RE: RFM69CW board: who has it working?
I only altered the code on the sending node, not on the receiving node.
The ‘0q’ output shown above is from the recei...
21:07 JeeLabs Café Support: RE: RFM69CW board: who has it working?
Real programmers are too lazy to enter ‘t’ manually ;-)
On the sender node I replaced:
if (Serial.available())
han...
18:15 JeeLabs Café Support: RE: RFM69CW board: who has it working?
I supplied the RFM69CW boards with 5V from the Unos.
Originally from a 5V header pin, put I had the impression that t...

2014-11-05

20:23 JeeLabs Café Support: RE: RFM69CW board: who has it working?
Thnx, this new code seems to work!
I replaced:
if (Serial.available())
handleInput(Serial.read(...

Also available in: Atom