General

Profile

JohnO

  • Registered on: 2012-10-02
  • Last connection: 2017-05-02

Issues

Projects

Activity

2017-05-18

22:50 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
Try both Arduino Uno and Arduino Duemilanove.
If you still have no joy please post some close up photographs of t...
22:38 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
When you say you have tried both I suspect you mean that you have tried the 5v and the 3v3 Sparkfun boards.
Pleas...
22:32 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
The pinout is visible here:
https://cdn.shopify.com/s/files/1/0032/7122/products/usb-bub2_large.jpg?v=1342201365
20:32 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
Did you adjust the PWR voltage from 3v3 to 5v on the 3v3 FTDI a per the Sparkfun schematic http://cdn.sparkfun.com/da...
17:53 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
http://jeelabs.net/projects/hardware/wiki/JeeNode
describes: v5 only - v6 check bridged on bottom side
17:46 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
It was buried a little but here it is: http://jeelabs.net/attachments/download/331/jlpcb-128.pdf
17:17 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
I have just checked the schematic http://cdn.sparkfun.com/datasheets/BreakoutBoards/FTDI%20Basic-v22-3.3V.pdf
Ther...
17:00 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
The ideal is 3v3 data pins with 5v driving the Jeenode onboard regulator.
16:48 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
~~Perhaps you will be OK with the 5v unit since the ATMega328 is OK with 5v on its data pins. The onboard radio card ...
16:33 JeeLabs Café Support: RE: Error uploading sketch to JeeNode V6. How to setup latest ver of Arduino IDE (v1.8.2) correctly?
No, definitely not.
The data lines are at 3v3 but the PWR is 5v.

Also available in: Atom