General

Profile

Rob

Issues

Projects

Activity

2015-03-12

12:14 JeeLabs Café JET (was: HouseMon): Housemon how to start?
Hi
I am trying to install Housemon on raspi and I am confused by the installations approaches:
The one described by...

2014-12-30

21:26 JeeLabs Café General: Kaku new protocol demo sketch
Hi,
For those who are interested, and inspired by the kaku demo sketch, I have made a new one for the so called kaku...

2014-12-04

14:10 JeeLabs Café Support: RE: RFMB12 (433) Excessive CRC errors
Martyn,
Thanks for your feedback, but unfortunately I don’t have a frequency meter or a scope.
Now something did hap...
11:40 JeeLabs Café Support: RFMB12 (433) Excessive CRC errors
Marty,
I have 3 modules withe the same type of crystal (a small one), but it look that only one is not working prope...
08:45 JeeLabs Café Support: RFMB12 (433) Excessive CRC errors
Hi,
I did recently acquire a new Jeenode with a RMFB12 433MHz module.
This new module is working, but compared with ...

2014-10-20

18:37 JeeLabs Café General: RE: RFM12B Board on ATMEGA2650 is not working
Here is the working configuration
18:15 JeeLabs Café General: RE: RFM12B Board on ATMEGA2650 is not working
OK I see my mistake,
The RF12.ccp specifies:
\#if defined(*AVR\_ATmega2560*) || defined(*AVR\_ATmega1280*)
\#defin...
15:00 JeeLabs Café General: RE: RFM12B Board on ATMEGA2650 is not working
I will check at the documentation of the ATMEGA 256 to verify the pinout and pin functions. (and the option in the RF...
14:50 JeeLabs Café General: RE: RFM12B Board on ATMEGA2650 is not working
Yes this is correct the RFM is powered with 3v3 and the Atmega signals are adapted from 5v to 3v3 via the resistor.
...
12:47 JeeLabs Café General: RE: RFM12B Board on ATMEGA2650 is not working
Hi,
The RFM board is connected to the 3v3 output of the Arduino.
The layout below shows the connexions
Robert
![](A...

Also available in: Atom