General

Profile

jhornbr225

Issues

Projects

Activity

2014-11-18

02:41 JeeLabs Café Support: Big Number Mode with LCD Plug?
I have an LCDPlug and have been using it with a 2x16 display. In an attempt to read the numbers on the display from a...

2014-01-20

20:36 JeeLabs Café Support: RE: Need help with using SPI Bus for 2 things on JeeNode
Yes, I’m using the Adafruit board at 3.3VDC. I already found that the signals are not understood at 5VDC.
I suppose ...
05:19 JeeLabs Café Support: Resolved: Need help with using SPI Bus for 2 things on JeeNode
I’m trying to read a temperature, display it on an LCDPlug that is local to the remote sensor JeeNode. I also want to...

2014-01-03

03:28 JeeLabs Café Support: RE: Need some help with an LCD Plug
Ok, I found the problem. I followed the instructions on several posts, including http://edvoncken.net/2011/12/assembl...

2014-01-02

18:08 JeeLabs Café Support: RE: Need some help with an LCD Plug
I soldered the 180Ohm to GND and now have light, but have nothing on the display, no matter the position of the contr...
16:27 JeeLabs Café Support: RE: Need some help with an LCD Plug
Well, since I am running the Demo sketch, where does that leave me? I have a scope, I suppose I can make sure data is...

2014-01-01

17:57 JeeLabs Café Support: RE: Need some help with an LCD Plug
OK, I’m using a bench supply at *5VDC to the P connection on one of port 4. I took a 1K and put it in the* connection...
17:49 JeeLabs Café Support: RE: Need some help with an LCD Plug
So take 3.3VDC and put it on the output pin of the chip? It does not seem like I have much time to do that “immediate...
17:34 JeeLabs Café Support: RE: Need some help with an LCD Plug
Ok, I put 16 to GND through a 180 Ohm, and it lights up.
16:26 JeeLabs Café Support: RE: Need some help with an LCD Plug
Thank you for responding on the holiday!
Yes, I saw that page and followed the directions.
“For the LCD from JeeLab...

Also available in: Atom