Project

General

Profile

Using the flashboard to program a attiny85 (help please)

Added by Wxll over 5 years ago

Hi,
I’m trying to use the flashboard to program a ATTINy85. Since this is the first time working with ISP I hope its just a simple dhu to get it working :~~)
Environment:
~~ Arduino software 1.0.5 with the https://github.com/damellis/attiny added in the hardware folder
- JeeNode with the https://github.com/jcw/jeelib/blob/master/examples/Ports/isp\_capture/isp\_capture.ino loaded
- I set the Programmer to “AvrISP” there is no option that says: “STK500/AVRISP programmer @ 19200 baud” as mentioned in the manualpage: http://jeelabs.org/2010/05/05/a-capturing-isp-programmer/
(please update the wiki so it reflects the current arduino software choices or how to add this to arduino)
In arduino I select the board “ATtiny85 (internal 8MHZ Clock)”

First I try to set the fuses by burning a boot loader ( I read I need to do that first? Is that still true in october 2013 ? ;-)
The green led blinks twice (than burning is succesful according the manual)
I get the following error in arduino:
*avrdude: please define PAGEL and BS2 signals in the configuration file for part ATtiny85
avrdude: Yikes! Invalid device signature.
Double check connections and try again, or use -F to override
this check.
*
Can I ignore this error or does it mean it didnt work?

Then I try to upload the blink sketch where i changed the pin 13 into 0
This gives the error:
avrdude: please define PAGEL and BS2 signals in the configuration file for part ATtiny85
avrdude: Yikes! Invalid device signature.
Double check connections and try again, or use F to override
this check.
Putting the Tiny on a wireboard and see if the led flashes does not do anything.
Do I need to use the regular upload or the upload-using-programmer ?
Looking at the serial port and pressing the button gives:
[isp_capture]
ISP bytes: 269
Code size: 0
Page size: 0
Data size: 0
Signature: 00 00 00 00 00 00 00 00 00 00 00
Programming…
Direction mismatch @ 16 : 0
That also does not looks like there is anything burned to the tiny
Many thanks for the help.. :
)

Wxll


Replies (2)

RE: Using the flashboard to program a attiny85 (help please) - Added by Wxll over 5 years ago

bump
Or is the print outdated and no longer supported :-/

    (1-2/2)