Project

General

Profile

rf12_control(0xC623)

Added by jeroenb 27 days ago

Hi,
I am usng jeenodes for years now. And I learned a lot.
Recently one om my jeenodes v4 with an rmf12b died (my fault) I replaced it with a rfm69. But that did not work. If I remove the "rf12_control(0xC623)" in my sketches the RFM69 works perfectly together with all other jeenodes.
But without the rf12_control(0xC623) command the range of the existing jeenodes is limited.
Is rf12_control(0xC623) supported with the RFM69 modules or is this only working on the RFM12b modules ?
regards

Jeroen

changing in file RF69/cpp from : 0x03, 0x02, // BitRateMsb, data rate = 49,261 khz to : 0x03, 0x0D, // BitRateMsb, data rate = 9,6 khz does the job.